Activator
Activator for cyanoacrylate adhesive
ACT-SUPGLU-CYANACRYLATE-150ML
Register now and access more than 125,000 products
The use of the activator can reduce the final strength of the adhesive used by approx. 20% compared to the ideal values.
Datasheets(X)
The activator accelerates the curing of instant adhesives and should always be used when work needs to be completed in seconds or when bonding inactive materials or very large gaps. In addition, excess adhesive can be completely cured by spraying them over with activator.
The activator can be applied by means of a small sponge, brush, by dipping or spraying onto the corresponding, cleaned surface. Apply the activator on one side, at least 2 minutes before the adhesive. The activator must evaporate completely before the parts are joined.
For more information, please refer to the technical data sheet.
Chemical basis | Aliphatic hydrocarbon |
Density | 0.7 g/cm³ |
Smell/fragrance | Characteristic |
Colour | Transparent |
Shelf life from production/conditions | 24 Month / at room temperature |
Contents | 150 ml |
Last viewed
Gypsum plasterboard screw
Sandpaper strip Useit® Superpad vehicle
Rechargeable battery Li-ion 18 V BASIC M-CUBE
Silicon carbide abrasive mesh For manual and machine processing
Spacer washer
Primer filler
Double pipe collars
K insulation pipe clamp With permanently integrated damping insert
Olive screw with AW drive and lathe centre
System bolt For system connector SV 20 E