Aluminium angle brackets Sheet metal roof
Mounting bracket for sheet-metal roofing
MNTBRKT-SOLCOLL-ALU-LL9MM-PL138X30X5
ZEBRA
Register now and access more than 125,000 products
Height compensation
Angle brackets can compensate unevenness of up to 20 mm using the slot
Fully pre-assembled
Mounting rails 39 x 37, 47 x 37 and 60 x 37 can be attached to the angle brackets without preparatory work
Bonded EPDM sealing strip on the bottom of the angle bracket
Optimum protection against moisture
- It should be ensured in advance that the sheet metal is sufficiently attached to the substructure. The maximum load-bearing capacity of the sheet metal should also be checked. Approval must be obtained from the manufacturer, particularly in the case of sandwich roofing elements. We recommend using two thin sheet metal screws with 4.5 x 25 sealing washer (art. no. 020154525) to attach each bracket.
- Not suitable for flat roof elevation mounting
Datasheets(X)
 | |
Base hole diameter | 5 mm |
Material | Aluminium |
Length | 138 mm |
Height | 64 mm |
Thickness | 5 mm |
Width | 30 mm |
Last viewed
Twist drill bit HSCo DIN 345 Type RN
Countersunk screw with hexagon socket head ISO 10642, steel, strength class 8.8, zinc-nickel-plated, silver (ZNSHL)
VARIFIX® base plate
Screw with flattened half round head and hexagon socket ISO 7380-1 steel 010.9, plain
Metal roofing anchoring point Anchor point Lock V standing seam
Plastic holder For combination wrench assortment
Cross cabinet hinge, heavy-duty
Hexagonal bolt with shank
Hexagon head sealing plug, short screw-in pin DIN 7604, steel, plain
Sanding sponge