Intumescent strip Plus
Intumescent strip plus
STR-INTUM-PLUS-100MM-10M-NSK
Register now and access more than 125,000 products
- The spacing of the wound insulation can be 0 mm
- Easy to install
- Does not drip in the event of fire
- No material exchange in fire areas
- Very little space requirement
- Easy to secure
Wall and ceiling ducts R 90 in solid components and in light partition walls P-3333/2736-MPA BS
Refer to the general construction test certificate for the materials, pipe outside diameters, pipe wall thicknesses and insulation thicknesses.
Clean opening
According tothe approval used
to lay the corresponding
installations
Close off remaining opening with fire-retardant mortar without leaving hollow spaces
Affix ID plate
Datasheets(X)
For use in system [H2]
- Pipe partition intumescent strip plus [H2]
- Fire resistance class R 90 in accordance with DIN 4102 Part 11
- For wall and ceiling ducts for non-flammable pipes that have flammable or non-flammable insulation, e.g. for cold piping insulated with cold natural rubber
- Material is laid around the insulation with a thickness of 1.5 mm (at least one layer; several layers for larger pipe diameters, pursuant to construction test certificate P-3333/2736-MPA BS) and fixed in place with a self-adhesive coating
Material is laid around the insulation with a thickness of 1.5 mm (at least one layer; several layers for larger pipe diameters, pursuant to construction test certificate P-3333/2736-MPA BS) and fixed in place with a self-adhesive coating
Thickness | 1.5 mm |
Length | 10 m |
Width | 100 mm |
| Dimensions: | ||
| Fire resistance rating | R 90 | |
| Material | Maximum pipe diameter | |
| Solid walls and ceilings | Light partition walls | |
| Insulation is laid and fixed with a self-adhesive coating. | ||
| Wall thickness of concrete and masonry | ≥ 150 mm | |
| Concrete ceiling thickness | ≥ 150 mm | |
| Wall thickness, light partition walls | ≥ 150 mm | |
| Steel and cast iron | ≥ 244 mm | ≥ 204 mm |
| Stainless steel | ≥ 244/204 mm | ≥ 204 mm |
| Copper | ≥ 88.9 mm | ≥ 108 mm |
| It is essential to refer to the general construction test certificates for the materials, pipe outside diameters, pipe wall thickness and insulation thicknesses. | ||
Last viewed
Stud with threaded end ≈ 2d DIN 835, steel 10.9, zinc flake, silver (ZFSHL)
HSS annular cutter
Double cylinder S5 locking system
Hand tap, taper tap HSS DIN 352
Hexagonal bolt with thread up to the head
Manual drive-in stamp For system connector
Pan head window sill screw with flange
WÜPOFAST® zinc-plated blue chipboard screw
Threaded pin For furniture castors
Double cylinder S5 locking system