Push-in quick-fit plug
Straight screw-in connector
SCRINCON-SR-D6-M10X1,0
Register now and access more than 125,000 products
Quick and easy pipe/hose installation and removal
Reduced risk of leaks
as there are fewer components
Corrosion-resistant brass design
Cost savings
thanks to reduction in installation and repair times
Complies with the international DIN, DOT and SAE regulations
Operating medium: Compressed air
Maximum operating pressure: In accordance with DIN 74324
Operating temperature: -40°C* to +100°C
(* at temperatures below +2°C please observe the air quality)
Hoses: In accordance with DIN 74324
Material:
- Connector body: Brass
- Pipe reinforcing sleeve: Brass, nickel-plated
- Multi-pronged tensioning clamp ring: Brass, nickel-plated
- O-ring: Buna N (low nitrile)
Above a certain length, pipes "vibrate", irrespective of whether they are made of steel, copper or plastic. Therefore, all brake line piping (5-16 mm diameter) should be secured on the body or on the frame using pipe clamps, rubberised if possible, wherein the distance should be 1 m and must not exceed 1.20 m.
Datasheets(X)
For polyamide pipes Ø 6 to 16 mm, for connecting components in the pneumatic brake system to commercial vehicles and auxiliary commercial vehicle systems.
Outer diameter of pipe (T) | 6 mm |
Connection thread (D/D1) | M10 x 1 |
Length (L) | 28.5 mm |
Material | Steel |
Last viewed
Cable tie KBL 2 black With plastic latch
Hexagonal bolt with shank
FLEXEN® cold rubber Plus S2 pipe insulation - 2 m
Tar rake handle For concrete spreader, aluminium/rubber squeegee
Hexagonal bolt with thread up to the head DIN 933, A2 stainless steel, plain
Hexagonal bolt with shank
Bag pressure piston
Plastic end cap, round For pipes
Stud with threaded end ≈ 1.25 d DIN 939, A4 stainless steel, plain
Base plate For Circo number plate holder