Satin-finish wheel brush Crimped stainless steel with hole
Stainless steel brush
BRSH-SST-SATNFINR-100X12X19MM
Register now and access more than 125,000 products
- Increased stability during brushing
- Crimped wire bristles support each other
- Uniform and consistent machining results due to uniform bristle arrangement
- For use on angle grinders
- Only the edge tips act on the workpiece. While excessive contact pressure does not improve the result, it does increase the required drive power and reduces the service life of the brush.
- Can be used on all standard stationary drive machines and bench grinders thanks to variable bore diameters.
- Always wear safety goggles and safety gloves when working with machine brushes!
Datasheets(X)
Deburring, cleaning and removal of oxide layers and paints
Diameter x width x drill hole | 100 x 12 x 19 mm |
Max. rotation speed | 8000 rpm |
Material of wire | Stainless steel |
Design | Corrugated |
Wire diameter | 0.2 mm |
Suitable for satin finisher (point system) | 4 of 4 points |
Aggressiveness | Middle |
EN standard | 1083-2 |
Last viewed
Grooved nut DIN 981, steel, plain, for clamping sleeve
Compression spring DIN 2095 spring steel wire, zinc-plated steel
C 6.3 TX bit (1/4 inch) C 6.3 (1/4 inch)
Twist drill bit HSCo DIN 338 type RN oxide
Hammer drill bit Plus EUROFAST 2-spiral
Hex head screw with thread up to head ISO 4017, A2-70 stainless steel, plain
ASSY® 4 CSMP universal screw Steel zinc plated partial thread countersunk milling pocket head
Hexagonal bolt with flange in accordance with MBN standard
Hexagonal bolt, fully threaded, SB fittings, DIN EN 15048-1
Mobile plastic upright distributor