Separator
Separator tool
SEPRTL-SPNW75MM
Register now and access more than 125,000 products
- This separator is used if puller hooks cannot reliably grip the part being extracted as it is seated too closely. The separating blades are mounted between the parts and pressed against each other. The wedge shape of the separating blade separates the assembly.
- The separator can also be used to remove thin parts, as the pull-off force acts on a large area. Prevents undesirable deformations and damage. The separating blades are mounted with the flat surface under the part to be removed.
- Drop-forged and hardened separating blades
- High-strength clamping screws
Datasheets(X)
 | |
Min./max. internal clamping width (A) | 14-75 mm |
Width of clamping jaw (B) | 115 mm |
Spindle length (C) | 170 mm |
Min./max. hole distance (E) | 76-139 mm |
Material of separating blade | Vanadium steel |
Surface of the separating blade | Zinc plated |
Thread dimension | M10 |
Last viewed
Horizontal clamp Basic With horizontal base and oil-resistant plastic handle
Shim ring DIN 988, steel, plain
Slotted countersunk head screw DIN 963, A2 stainless steel, plain
Concealed hinge TIOMOS click-on 110
Twist drill bit HSS DIN 345 type RN
Twist drill bit HSS DIN 338 type RN 118°
Hexagonal bolt with shank DIN 601, steel 4.6, zinc-plated, blue passivated (A2K), with nut
Round-headed strip nails, 21°
HSS-Co8 end mill, short DIN 844K
Wing screw, square wings Similar to DIN 316, A2 stainless steel, plain